Python3 support for Pyradmon

hi to everyone,

i'm new here, and to start submit CPM to radmon.org webservice with raspberry, i had to modify the source of Pyradmon.py to comply the new Python3.x sintax standard.
I hope it can help someone else.
i'm currently use Raspberry3A+ with Raspbian x64 minimal installation.
this attached file is the no sound version of Pyradmon on github.
 

greetings,
Bg
 

It WORKS right out of the box.
Thank you many times.

Regards Erik Nielsen, OZ1EWR

Thank you so much for doing this; however, I cannot get it to work with my setup. I was hoping you might have some advice. I am running an RH Electronics MyGeiger 2.0 and a Pi 400 running bullseye. When I run  Py3Radmon.py  I get the following error:

Problem in getData procedure (disconnected USB device?) => geiger 1; can only concatenate str ("not bites") to str

thoughts?

thanks
-Mark 

Thanks for this!

This came in very handy as I recently upgraded my Raspberry Pi and installed the latest Software. I could have gone back to Python2 but there were only about 5-6 lines of code. Working again.

Thanks for the conversion as I am using a custom version that was hand timed to work with my older GMC detector. I really didn't want to go back and edit all the sections to alter delays and such.