Austin TX

More
9 years 11 months ago - 9 years 11 months ago #383 by jnissen
Austin TX was created by jnissen
Hello I have a GMC-300 detector I have been using with the RadioActive@Home network. To participate in that system you have to run the BOINC application and it's a lot of overhead to just report CPM. Just ran across this site and want to give it a try.

The detector appears to be supported in the software so I should be good to go. I tested it and it does seem to connect and read just fine.
Last edit: 9 years 11 months ago by jnissen.

Please Log in or Create an account to join the conversation.

More
9 years 11 months ago #384 by maredentro72
Replied by maredentro72 on topic Austin TX
Great job. welcome.

Alberto

Please Log in or Create an account to join the conversation.

More
9 years 11 months ago #385 by Juzzie
Replied by Juzzie on topic Austin TX
Welcome,
Log on!

Owner and operator of "southofhobart" monitoring stations.

Please Log in or Create an account to join the conversation.

More
9 years 11 months ago #390 by mw0uzo
Replied by mw0uzo on topic Austin TX
Welcome jnissen!
For minimum resource usage in RadLog, enable the 'Unbloat' option and restart RadLog. This option eliminates the browser component used for displaying the live map.
Your account is set up, any problems let me know :)

Please Log in or Create an account to join the conversation.

More
9 years 11 months ago #400 by jnissen
Replied by jnissen on topic Austin TX
Amazing site and tool you have produced here. I literally spent about five minutes and the site is already showing up on the map. Thank you. Much more user friendly then other monitoring sites I have dealt with.
The following user(s) said Thank You: mw0uzo

Please Log in or Create an account to join the conversation.

More
9 years 11 months ago #404 by Frank
Replied by Frank on topic Austin TX

Hello I have a GMC-300 detector I have been using with the RadioActive@Home network. To participate in that system you have to run the BOINC application and it's a lot of overhead to just report CPM. Just ran across this site and want to give it a try.

The detector appears to be supported in the software so I should be good to go. I tested it and it does seem to connect and read just fine.


Hi there, ya, I tried that too with that site, what a pain and yes, the BOINC software does pull the PC down and I already have a project running on it for my earthquake sensor here. This site was the best and eay to set up and run and is always up and running and lots of support! :)

Please Log in or Create an account to join the conversation.

Moderators: Gamma-Man
Time to create page: 0.187 seconds
Powered by Kunena Forum
Everything's free. Please support us by considering a donation. Log in first!
Solar powered Raspberry Pi 4 server stats: CPU 30% Memory 13% Swap 7% CPU temp=54.5'C Uptime 5 Days